From 1e18601b0783614e0c85d70c2348944a9cb75d1b Mon Sep 17 00:00:00 2001 From: Quentin Young Date: Wed, 18 Jul 2018 19:22:14 +0000 Subject: [PATCH] doc: cleanup rpki.rst Previous commit on this file introduced formatting issues. Signed-off-by: Quentin Young --- doc/user/rpki.rst | 50 ++++++++++++++++++++++++----------------------- 1 file changed, 26 insertions(+), 24 deletions(-) diff --git a/doc/user/rpki.rst b/doc/user/rpki.rst index 38b2b68e98..59a0d3c226 100644 --- a/doc/user/rpki.rst +++ b/doc/user/rpki.rst @@ -60,7 +60,8 @@ Enabling RPKI This command enables the RPKI configuration mode. Most commands that start with *rpki* can only be used in this mode. - When it is used in a telnet session, leaving of this mode cause rpki to be initialized. + When it is used in a telnet session, leaving of this mode cause rpki to be + initialized. Executing this command alone does not activate prefix validation. You need to configure at least one reachable cache server. See section @@ -70,29 +71,30 @@ Enabling RPKI .. index:: daemons.conf - When first installing FRR with RPKI support from the pre-packaged binaries. Remember - to append '-M rpki' in the /etc/frr/daemons.conf file to the bgpd_options. - - bgpd_options=" --daemon -A 127.0.0.1 -M rpki" - instead of the default setting - bgpd_options=" --daemon -A 127.0.0.1" - - - Else you will encounter an error when trying to enter RPKI configuration mode. Because - the rpki module is not loaded when the BGP daemon is initialized. - - Examples of the error: - - router(config)# debug rpki - % [BGP] Unknown command: debug rpki - - router(config)# rpki - % [BGP] Unknown command: rpki - - Note that the rpki commands will be available in vtysh when running 'find rpki'. - Even if the RPKI module is NOT loaded. - The RPKI commands will be unavailable if you try running the same command in the - cli specific to the BGP daemon. + When first installing FRR with RPKI support from the pre-packaged binaries. + Remember to append :option:`-M rpki` in the :file:`/etc/frr/daemons.conf` + file to ``bgpd_options``, like so:: + + bgpd_options=" --daemon -A 127.0.0.1 -M rpki" + + instead of the default setting:: + + bgpd_options=" --daemon -A 127.0.0.1" + + Otherwise you will encounter an error when trying to enter RPKI + configuration mode due to the ``rpki`` module not being loaded when the BGP + daemon is initialized. + + Examples of the error:: + + router(config)# debug rpki + % [BGP] Unknown command: debug rpki + + router(config)# rpki + % [BGP] Unknown command: rpki + + Note that the RPKI commands will be available in vtysh when running ``find + rpki`` regardless of whether the module is loaded. Configuring RPKI/RTR Cache Servers ---------------------------------- -- 2.39.5