Donald Sharp [Fri, 21 Sep 2018 15:41:46 +0000 (11:41 -0400)]
pimd: blackhole traffic when we are not DR for Stream received
Suppose we have a bridge with a host and two routers attached
to it.
r1 r2
| |
--------
|
host
host is sending traffic.
r1 and r2 are pim neighbors and r2 is the DR.
Both r1 and r2 will receive data from the stream up the pim
kernel socket. r1 will notice that it is not the DR and
stop processing in pim. This code adds a bit more code to blackhole
the route when r1 detects it is not the DR in this scenario.
This is being done because the kernel is both keeping state and
sending data to the pim process to continue processing this.
Additionally if we happen to be running this on a asic, then
blackholing the route in the asic can save a significant amount
of cpu time handling this situation.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
Donald Sharp [Fri, 21 Sep 2018 14:28:57 +0000 (10:28 -0400)]
pimd: Add a debug to tell why we are not creating upsteam state
When we decide we are not the right pim process to add upstream state
for the igmp state received, notice this in a debug to make life
easier to debug.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
There were checks for null pointer after being dereferenced. Checks have
been removed (we've discussed the no need of adding assert()'s because
of similar code not requiring them).
F. Aragon [Tue, 4 Sep 2018 12:37:00 +0000 (14:37 +0200)]
zebra: filter zebra messages (label manager)
This change makes the zebra acting as label manager proxy not to relay non-LM
messages to clients that a zebra acting in non-proxy mode may send to it. Also,
the existing code does not schedule a rcv in case of relay_response_back
returns -1. This patch re-schedules reads on the socket even in case such a
function returns -1 by calling thread_add_read().
paco [Thu, 7 Jun 2018 13:28:12 +0000 (15:28 +0200)]
bgpd, doc, ldpd, lib, tests, zebra: LM fixes
Corrections so that the BGP daemon can work with the label manager properly
through a label-manager proxy. Details:
- Correction so the BGP daemon behind a proxy label manager gets the range
correctly (-I added to the BGP daemon, to set the daemon instance id)
- For the BGP case, added an asynchronous label manager connect command so
the labels get recycled in case of a BGP daemon reconnection. With this,
BGPd and LDPd would behave similarly.
Netdevices are not sorted in any fashion by the kernel during the initial
interface nldump. So you can get an upper device (such as an SVI) before
its corresponding lower device (bridge).
To fix this problem we skip resolving link dependencies during handling of
nldump notifications. Resolving instead at the end (when all the devices
are present)
Signed-off-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com>
Ticket: CM-22388, CM-21796
Reviewed By: CCR-7845
Testing Done:
1. verified on a setup with missing linkages
2. automation - evpn-min
Ensure that when the is_router condition changes for a locally learnt
neighbor, it is informed to BGP only if it is active i.e., the MAC is
also locally learnt.
Use boolean variables instead of unsigned int for certain VxLAN-EVPN
flags which are really used as boolean.
Signed-off-by: Vivek Venkatraman <vivek@cumulusnetworks.com> Reviewed-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com> Reviewed-by: Chirag Shah <chirag@cumulusnetworks.com>
Ticket: CM-22288
Reviewed By: CCR-7832
Testing Done:
Along with a subsequent, related commit
vivek [Wed, 29 Aug 2018 00:22:04 +0000 (17:22 -0700)]
zebra: Uninstall remote MACs from kernel appropriately
When a remote MAC goes away, but there are neighbors referring to it,
ensure that when the last remote neighbor goes away, the MAC is
uninstalled from the kernel and no longer considered as remote.
Signed-off-by: Vivek Venkatraman <vivek@cumulusnetworks.com> Reviewed-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com> Reviewed-by: Chirag Shah <chirag@cumulusnetworks.com>
Ticket: CM-22130
Reviewed By: CCR-7777
Testing Done:
1. Replicated failed scenario and verified with fix.
2. evpn-min
Donald Sharp [Mon, 17 Sep 2018 17:58:59 +0000 (13:58 -0400)]
pimd: Actually create vif's in non-integrated config
The startup of a non-integrated config was not properly
allowing for startup to create the vif when we have
not learned about the interface we are trying to configure
at this point in time. Actually notice when we are
trying to create a pimreg device or not to properly
notice when to attempt to create the vif or not.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
Donald Sharp [Mon, 17 Sep 2018 13:18:40 +0000 (09:18 -0400)]
zebra: Send correct default vrf tableid for MROUTE stats
So the linux kernel uses the RT_TABLE_MAIN for the table
id used for ip routing. The multicast routing tables use
RT_TABLE_DEFAULT. We changed the internal code of zebra_vrf
a few months back to use RT_TABLE_MAIN as the tableid to
use. This caused the pim sg stats to stop working because
of the kernel bug where it uses a different table
for ip routing and ip multicast.
Put a bit of a special case in to do the right thing.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
Donald Sharp [Fri, 14 Sep 2018 21:54:11 +0000 (17:54 -0400)]
zebra: Newer kernels send data about mroute changes
Newer linux kernels apparently send data down the netlink
bus for the creation of mroutes. Add a bit of code
to notice this and to handle it appropriately( ie do
nothing at this point in time ) as that the correct
place to do this is in the pim socket in pimd.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
Donald Sharp [Fri, 14 Sep 2018 20:30:17 +0000 (16:30 -0400)]
staticd: Allow table_id to be a distinguisher for installation
The table_id should be a discriminator in the installation of
static routes into zebra from staticd. Add this to allow the end
user to do something like this:
ip route 4.5.6.7/32 192.168.209.44
ip route 4.5.6.7/32 192.168.209.44 table 3000
ip route 4.5.6.7/32 192.168.209.45 table 3000
robot# show ip route
Codes: K - kernel route, C - connected, S - static, R - RIP,
O - OSPF, I - IS-IS, B - BGP, E - EIGRP, N - NHRP,
T - Table, v - VNC, V - VNC-Direct, A - Babel, D - SHARP,
F - PBR, f - OpenFabric,
> - selected route, * - FIB route
K>* 0.0.0.0/0 [0/101] via 192.168.201.1, enp0s3, 00:01:40
S>* 4.3.2.1/32 [1/0] via 192.168.210.4, enp0s10, 00:01:35
S>* 4.3.2.2/32 [1/0] via 192.168.209.4, enp0s9, 00:01:35
S>* 4.5.6.0/26 [1/0] via 192.168.210.4, enp0s10, 00:01:35
S>* 4.5.6.7/32 [1/0] via 192.168.209.44, enp0s9, 00:01:35
C>* 192.168.201.0/24 is directly connected, enp0s3, 00:01:40
C>* 192.168.208.0/24 is directly connected, enp0s8, 00:01:40
C>* 192.168.209.0/24 is directly connected, enp0s9, 00:01:40
C>* 192.168.210.0/24 is directly connected, enp0s10, 00:01:40
robot# show ip route table 3000
Codes: K - kernel route, C - connected, S - static, R - RIP,
O - OSPF, I - IS-IS, B - BGP, E - EIGRP, N - NHRP,
T - Table, v - VNC, V - VNC-Direct, A - Babel, D - SHARP,
F - PBR, f - OpenFabric,
> - selected route, * - FIB route
S>* 4.5.6.7/32 [1/0] via 192.168.209.44, enp0s9, 00:00:55
* via 192.168.209.45, enp0s9, 00:00:55
robot#
Fixes: #2954 Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
F. Aragon [Fri, 14 Sep 2018 12:53:55 +0000 (14:53 +0200)]
bgpd: type fix
For tracking the last state of the penalty (struct bgp_damp_info) a 'double'
type was used instead of using the 'unsigned int' being used in the structure.
Detected using ./configure CFLAGS=-Wfloat-equal CC=clang
Donald Sharp [Thu, 6 Sep 2018 14:51:08 +0000 (10:51 -0400)]
bgpd: Prevent possible crash when parsing v6 attributes
The peer->nexthop.ifp pointer must be set when parsing the
attributes in bgp_mp_reach_parse, notice this
and fail gracefully.
Rework bgp_nexthop_set to remove the HAVE_CUMULUS and to
fail the nexthop_set when we have a zebra connection and
no ifp pointer, as that not havinga zebra connection and
no ifp pointer is legal.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
pimd: create a new command "ip pim" configuring pim sm
A new command "ip pim" is created to configure pim sm on an
interface, which replaces the existing commands "ip pim sm"
and "ip pim ssm" and make "ip pim sm" and "ip pim ssm" as
hidden commands. The command "ip multicast-routing" is removed
since it is already enabled on FRR by default.
Donald Sharp [Mon, 10 Sep 2018 14:19:03 +0000 (10:19 -0400)]
bgpd: Honor origin change in bgp aggregates
When the origin changed we must honor and update the aggregate
to the peer. This code adds a bit of code to the bgp_aggregate_info_same
code to see if the origin has changed and to indicate that it has.
Fixes: #2993 Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
projects / matthieu / frr.git / log